That in turn, calls twi.h/twi.c which imports a WHOLE bunch of the more hardcore libraries from various sources, such as Atmel, the chip manufacturer. When you’re writing Wire.begin(), that command is defined in Wire.h / Wire.cpp. Now it’s not a perfect analogy, but you can think of these files as creating a machine, where Wire.h/Wire.cpp are the parts that let you write the easy-to-understand Arduino code, and twi.h/twi.c are the parts that take your easy-to-understand code and reconfigure it to something the C compiler wants to chew on. There are several files in that path, including the example code that is available to you in the IDE, but the heart of I2C communications with an Arduino resides in four files… The library and files all contain the word “wire” because Atmel (the chip at the heart of the Arduino) devised a system called “Two Wire Interface” or “TWI” which is their flavor of I2C. Arduino/libraries/Wire directory on the machine you write your code on. The Wire Library is a series of files in plain text that exist in the. Additionally, if you wish to replicate the oscilloscope traces, use any two channel oscilloscope capable of reading a 100kHz signal connected to the SDA and SCL lines between an Arduino and any I2C chip, and then send each function listed below as necessary with sufficient delay time in between to allow you to view the resulting scope trace. Be very careful when opening those files though, that you don’t modify them or you’ll need to reinstall everything from scratch. No setup is required, however you can access the files that comprise the wire library in the program folders installed with your Arduino IDE. No schematic is associated with this module.
0 kommentar(er)
